Battery Charger Tips (1powershop)

Battery Charger Tips
Tip 1: The wires coming out of the charger should be long enough to reach the transformer (brick) and still allow the charger board to rest on a flat surface.
Tip 2: You might want to use some heat shrink (available in the lab) or tape to combine the wires coming out the board. This will help prevent them from tangling.
Tip 3: The charger board has an exposed metal back!
Tip 4: The wires from the charger board connect to the MIDDLE two scews on the transformer. Do NOT over tighten the screws or they might break!
· Once charging is complete, remove Mobile-charger from device and disconnect the cable from the Mobile-Charger
· Do not leave cable connected to Mobile-Charger when not in use
· 1 - 2 chargings are typical from one alkaline AA battery and device